Parking AC driver startup and first use — step-by-step operation guide

• Table of Contents

1. Pre-startup check
2. Control panel walkthrough
3. Recommended first-night settings
4. Common first-use questions

First-time parking AC operation should take less than 60 seconds end-to-end. This guide walks new drivers through the startup sequence, control panel functions and recommended first-night settings to build confidence with the system from day one.

Pre-startup check

Confirm battery voltage adequate (Vethy display shows green status). Confirm cabin windows closed. Confirm air outlets unobstructed. If recently installed, allow 5 minutes after engine-off for system self-check.

Control panel walkthrough

Power button: press to start. Temperature: up/down arrows to set target (typically 22°C / 72°F first use). Fan speed: low / medium / high cycle button. Mode: cool / sleep mode toggle. Timer: optional auto-stop selection.

Recommended first-night settings

Set 22°C / 72°F, medium fan, sleep mode enabled. Sleep mode automatically reduces fan over the rest period for quieter operation. Battery monitor display shows estimated run-time remaining.

Common first-use questions

Quiet operation: this is normal. System is designed for sub-50 dB cabin noise. Cool-down time: 8–15 minutes from hot cabin to set point depending on ambient. Battery management: system auto-stops if voltage falls to protected threshold.

Frequently asked questions

How long does first cool-down take?

8–15 minutes from hot cabin to set point. Pre-cooling on shore power before parking accelerates first-night comfort.

Should I leave the AC running all night?

Yes when battery and ambient conditions support full-night operation. System monitors battery and protects automatically.

What temperature setting is recommended?

22°C / 72°F is the comfort-research recommended sleep temperature. Adjust by 1–2 degrees based on personal preference.